FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
15. COMPENSATION FUNCTION
287
Offset calculation is carried out in the plane determined by G17, G18 and
G19, (G codes for plane selection). This plane is called the offset plane.
Compensation is not executed for the coordinate of a position which is not
in the specified plane. The programmed values are used as they are.
In simultaneous 3 axes control, the tool path projected on the offset plane
is compensated.
The offset plane is changed during the offset cancel mode. If it is
performed during the offset mode, a P/S alarm (No. 37) is displayed and
the machine is stopped.
D Plane selection and
vector

Leave a Reply

Your email address will not be published. Required fields are marked *