FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
15. COMPENSATION FUNCTION
293
If the command is specified at start–up, the offset vector is not created.
S
N9
N6
N7
N8
SS
G91 G40 ;
:
N6 X100.0 Y100.0 ;
N7 G41 X0 ;
N8 Y–100.0 ;
N9 Y–100.0 X100.0 ;
Programmed path
Tool center path
r
NOTE
For the definition of blocks that do not move the tool, see
II–15.6.3.
D A block without tool
movement specified at
start–up

Leave a Reply

Your email address will not be published. Required fields are marked *