FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
15. COMPENSATION FUNCTION
B–62764EN/01
294
In the offset mode, the tool moves as illustrated below:
α
L
L
α
C
S
L
S
C
L
S
C
S
C
LinearCircular
LinearLinear
Programmed path
Intersection
Tool center path
Workpiece
Work-
piece
Tool center path
Intersection
Programmed path
Workpiece
Programmed path
Tool center path
Intersection
CircularLinear
CircularCircular
Work-
piece
Tool center path
Programmed path
Intersection
α
α
15.6.3
Tool Movement in
Offset Mode
Explanations
D Tool movement around
the inside of a corner
(180°α)

Leave a Reply

Your email address will not be published. Required fields are marked *