FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
15. COMPENSATION FUNCTION
B–62764EN/01
314
Tool overcutting is called interference. The interference check function
checks for tool overcutting in advance. However, all interference cannot
be checked by this function. The interference check is performed even if
overcutting does not occur.
(1) The direction of the tool path is different from that of the programmed
path (from 90 degrees to 270 degrees between these paths).
Tool center path Programmed path
Programmed path
Tool center path
The directions of
these two paths are
different (180°).
The directions of
these two paths are
different (180°).
15.6.5
Interference Check
Explanations
D Criteria for detecting
interference

Leave a Reply

Your email address will not be published. Required fields are marked *