FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
15. COMPENSATION FUNCTION
319
When the radius of a corner is smaller than the cutter radius, because the
inner offsetting of the cutter will result in overcuttings, an alarm is
displayed and the CNC stops at the start of the block. In single block
operation, the overcutting is generated because the tool is stopped after
the block execution.
Tool center path
Programmed path
Workpiece
An alarm is generated
and the operation
stops
An alarm is generated and
the operation stops here in
single block operation
If the CNC does not
stop, overcutting occurs
Since the cutter compensation forces the path of the center of the tool to
move in the reverse of the programmed direction, overcutting will result.
In this case an alarm is displayed and the CNC stops at the start of the
block.
Tool center path
Programmed path
Workpiece
An alarm is displayed and the operation
stops
Overcutting if the operation would not stop
15.6.6
Overcutting by Cutter
Compensation
Explanations
D Machining an inside
corner at a radius
smaller than the cutter
radius
D Machining a groove
smaller than the tool
radius

Leave a Reply

Your email address will not be published. Required fields are marked *