FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
1. GENERAL
B–62764EN/01
14
Movement of the tool at a specified speed for cutting a workpiece is called
the feed.
Tool
Workpiece
Table
F
mm/min
Fig. 1.2 (a) Feed function
Feedrates can be specified by using actual numerics. For example, to feed
the tool at a rate of 150 mm/min, specify the following in the program:
F150.0
The function of deciding the feed rate is called the feed function (See
II–5).
1.2
FEED–
FEED FUNCTION

Leave a Reply

Your email address will not be published. Required fields are marked *