FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
15. COMPENSATION FUNCTION
345
When one of the following G codes is specified in three–dimensional tool
compensation mode, the vector is cleared:
G73 Peck drilling cycle
G74 Reverse tapping cycle
G76 Fine boring
G80 Canned cycle cancel
G81 Drill cycle, spot boring
G82 Drill cycle, counterboring
G83 Peck drilling cycle
G84 Tapping cycle
G85 Boring cycle
G86 Boring cycle
G87 Back boring cycle
G88 Boring cycle
G89 Boring cycle
G53 Machine coordinate system selection
When one of the following G codes is specified in three–dimensional tool
compensation mode, the same vector as the vector generated in the
previous block is generated at the end point of the next movement:
G02 Circular or helical interpolation (CW)
G03 Circular or helical interpolation (CCW)
G02.2 Involute interpolation (CW)
G03.2 Involute interpolation (CCW)
G04 Dwell
G10 Data setting
G22 Stored stroke check function enabled
D Commands that clear the
vector
D Commands that generate
the same vector as the
vector in the previous
block

Leave a Reply

Your email address will not be published. Required fields are marked *