FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
15. COMPENSATION FUNCTION
357
2. When the system is in cutter compensation model C, specify the
commands in the following order (Fig.15.10(e)) :
(cutter compensation C cancel)
G51 ; scaling mode start
G68 ; coordinate system rotation start
:
G41 ;cutter compensation C mode start
:
When only coordinate
system rotation is applied
When scaling and coordinate
system rotation are applied
When only scaling
is applied
Cutting program
0
100.0
200.0
200.0 400.0
X
Y
G92 X0 Y0 ;
G51 X300.0 Y150.0 P500 ;
G68 X200.0 Y100.0 R45.0 ;
G01 X400.0 Y100.0 ;
Y100.0 ;
X–200.0 ;
Y–100.0 ;
X200.0 ;
Fig15.10 (e) Scaling and coordinate system rotation
in cutter compensation C mode

Leave a Reply

Your email address will not be published. Required fields are marked *