FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
1. GENERAL
B–62764EN/01
18
(2)Mounting a workpiece directly against the jig
Jig
Program zero point
Meet the tool center to the reference position. And set the coordinate system
specified by CNC at this position. (Jig shall be mounted on the predetermined
point from the reference position.)
(3)Mounting a workpiece on a pallet, then mounting the workpiece and
pallet on the jig
Pallet
(Jig and coordinate system shall be specified by the same as (2)).
Jig
Workpiece

Leave a Reply

Your email address will not be published. Required fields are marked *