FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
1. GENERAL
19
Command for moving the tool can be indicated by absolute command or
incremental command (See II–9.1).
The tool moves to a point at “the distance from zero point of the
coordinate system” that is to the position of the coordinate values.
B(10.0,30.0,20.0)
X
Tool
A
Command specifying movement from
point A to point B
Z
G90 X10.0 Y30.0 Z20.0 ;
Coordinates of point B
Specify the distance from the previous tool position to the next tool
position.
X
Z
A
B
X=40.0
Z=–10.0
G91 X40.0 Y–30.0 Z–10.0
;
Distance and direction for
movement along each axis
Tool
Command specifying movement from
point A to point B
Y=–30.0
1.3.3
How to Indicate
Command Dimensions
for Moving the Tool –
Absolute, Incremental
Commands
Explanations
D Absolute command
D Incremental command

Leave a Reply

Your email address will not be published. Required fields are marked *