FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
1. GENERAL
21
When drilling, tapping, boring, milling or the like, is performed, it is
necessary to select a suitable tool. When a number is assigned to each tool
and the number is specified in the program, the corresponding tool is
selected.
01
02
Tool number
ATC magazine
<When No.01 is assigned to a drilling tool>
When the tool is stored at location 01 in the ATC magazine, the tool
can be selected by specifying T01. This is called the tool function (See
II–11).
1.5
SELECTION OF TOOL
USED FOR VARIOUS
MACHINING – TOOL
FUNCTION
Examples

Leave a Reply

Your email address will not be published. Required fields are marked *