FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
16. CUSTOM MACRO
B–62764EN/01
400
By setting an M code number used to call a macro program in a parameter,
the macro program can be called in the same way as with a simple call
(G65).
O0001 ;
:
M50 A1.0 B2.0 ;
:
M30 ;
O9020 ;
:
:
:
M99 ;
Parameter No.6080 = 50
By setting an M code number from 1 to 99999999 used to call a custom
macro program (9020 to 9029) in the corresponding parameter (No.6080
to No.6089), the macro program can be called in the same way as with
G65.
O9020
O9021
O9022
O9023
O9024
O9025
O9026
O9027
O9028
O9029
6080
6081
6082
6083
6084
6085
6086
6087
6088
6089
Program number Parameter number
As with a simple call, a number of repetitions from 1 to 9999 can be
specified at address L.
As with a simple call, two types of argument specification are available:
Argument specification I and argument specification II. The type of
argument specification is determined automatically according to the
addresses used.
S An M code used to call a macro program must be specified at the start
of a block.
S In a macro called with a G code or in a program called as a subprogram
with an M or T code, no macros can be called using an M code. An M
code in such a macro or program is treated as an ordinary M code.
16.6.4
Macro Call Using
an M Code

D Correspondence
between parameter
numbers and program
numbers
D Repetition
D Argument specification


Leave a Reply

Your email address will not be published. Required fields are marked *