FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
1. GENERAL
B–62764EN/01
24
The block and the program have the following configurations.
N ffff G ff Xff.f Yfff.f M ff S ff T ff ;
1 block
Sequence
number
Preparatory
function
Dimension word Miscel-
laneous
function
Spindle
function
Tool
func-
tion
End of
block
Fig. 1.7 (b) Block configuration
A block starts with a sequence number to identify the block and ends with
an end–of–block code.
This manual indicates the end–of–block code by ; (LF in the ISO code and
CR in the EIA code).
;
Offff;
M30 ;
Program number
Bloc
k
Bloc
k
Bloc
k
End of program
Fig. 1.7 (c) Program configuration
Normally, a program number is specified after the end–of–block (;) code
at the beginning of the program, and a program end code (M02 or M30)
is specified at the end of the program.
Explanations
D Block
D Program

Leave a Reply

Your email address will not be published. Required fields are marked *