FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
18. PROGRAMMABLE PARAMETER
ENTRY (G10)
435
1. Set bit 2 (SPB) of bit type parameter No. 3404
G10L50 ; Parameter entry mode
N3404 R 00000100 ; SBP setting
G11 ; cancel parameter entry mode
2. Change the values for the Z–axis (3rd axis) and A–axis (4th axis) in
axis type parameter No. 1322 (the coordinates of stored stroke limit
2 in the positive direction for each axis).
G10L50 ; Parameter entry mode
N1322P3R4500 ; Modify Z axis
N1322P4R12000 ; Modify A axis
G11 ; cancel parameter entry mode
Examples

Leave a Reply

Your email address will not be published. Required fields are marked *