FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
20. HIGH SPEED CUTTING FUNCTIONS
B–62764EN/01
442
In the look–ahead control mode, the functions listed below cannot be
specified. To specify these functions, cancel the look–ahead control
mode, specify the desired function, then set look–ahead control mode
again.
Rigid tapping function
Cs contour axis control function
Feed per rotation
Feed at address F with one digit
C–axis normal direction control function
Polar coordinate interpolation function
Cylindrical interpolation function
Involute interpolation function
Exponential interpolation
Three–dimensional coordinate conversion
Retrace function
Normal direction control
Polar coordinate command
Index table indexing
Tool withdrawal and return
Threading and synchronous feed
High–speed cycle machining
Handle interrupt
Program restart
Simplified synchronization control
Feed stop
High–speed skip function
Constant surface speed control
Interrupt type custom macro
Small–diameter peck drilling cycle
High–speed remote buffer A/B
Automatic tool length measurement
Skip cutting
G28 (low–speed reference position return)
D Functions that cannot be
specified

Leave a Reply

Your email address will not be published. Required fields are marked *