FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
20. HIGH SPEED CUTTING FUNCTIONS
B–62764EN/01
448
I, J, K, R : I, J, K, and R specified for circular interpolation
Data for movement along axis : Data for moving the tool along the
axis set in parameter No. 1020 (any
axis selected from X, Y, Z, U, V, W, A,
B, and C)
( ) : Control–in and control–out commands
(comment specification)
/n : Optional block skip command (n is a number.)
Mxxxx : Auxiliary function (Note)
Sxxxx : Auxiliary function (Note)
Txxxx : Auxiliary function (Note)
Bxxxx : Auxiliary function (Note)
M98, M198, etc. : Subprogram call
NOTE
G00, auxiliary functions, subprogram call (M98, M198), and macro
call M and T codes can be specified in the HPCC mode only when
bit 1 of parameter MSU No. 8403 is 1. If these codes are specified
when MSU is not 1, an alarm is issued.
In the HPCC mode, specifying unspecifiable data causes an alarm. To
specify a program containing unspecifiable data, specify G05P0 to exit
from the HPCC mode before specifying the program.
< Sample program >
O0001 ;
G05P10000 ; HPCC–ON
G00X100.Y200. ;
G91G01X100Y200Z300F2000 ;
X200Y300Z400 ;
X300Y400Z500 ;
X400Y500Z600 ;
X300Y400Z500 ;
M98P0002 ; SUB PROGRAM
X10. ;
G05P0 ; HPCC–OFF
G90G51X0Y0Z0 ;
X500Y400Z300 ;
X600Y500Z400 ;
G50 ;
G05 P10000 ; HPCC–ON
X100Y200 ;
X200Y400 ;
G05P0 ; HPCC–OFF
G04X3. ;
M30 ;
O0002 ;
G00X50.Y50. ;
M11 ;
G02I20.F3000 ;
G01X100. ;
G03I80. ;
G01X–50. ;
G02I100.F5000 ;
G01X200.Y300.F1500 ;
X50.Y100.Z150. ;
T24 ;
M99 ;
Main program
Subprogram
Note) When bit 1 of parameter MSU
No. 8403 is 1
D When unspecifiable data
is specified

Leave a Reply

Your email address will not be published. Required fields are marked *