FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
20. HIGH SPEED CUTTING FUNCTIONS
451
N6
N7 N8
N6 G91 X100. Z100. ;
N7 G40 ;
N8 X100. ;
N6 G91 X100. Z100. ;
N7 G40 ;
N8 G05 P0 ;
If cutter compensation mode is canceled while a vector still remains
and HPCC mode is canceled before a move command is specified,
the P/S alarm No.5013 is issued.
The P/S alarm No. 5013 is issued.
(3)When an offset value is changed during cutter compensation C in
HPCC mode, the new offset value is not used until a block specifying
a D code appears.

Leave a Reply

Your email address will not be published. Required fields are marked *