FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
20. HIGH SPEED CUTTING FUNCTIONS
B–62764EN/01
456
During high–speed machining, the distribution processing status is
monitored. When distribution processing terminates, P/S alarm No. 000
and P/S alarm No. 179 are issued upon completion of the high–speed
machining command (according to the setting of ITPDL (bit 7 of
parameter No. 7501)).
These P/S alarms can be canceled only by turning off the CNC power.
High–speed machining using the high–speed remote buffer A function,
high–speed remote buffer B function, and high–speed cycle function
based on the G05 command
Failure to perform normal distribution processing because distribution
processing required for high–speed machining exceeded the CNC
processing capacity, or because distribution data sent from the host was
delayed for some reason while the high–speed remote buffer A or G
function was being used
Alarm
Alarm No. Message Contents
000
During high–speed machining, distribution pro-
cessing was terminated.
Related parameters:
Remote buffer transfer baud rate (parameter
No 133)
79
No
.
133)
Number of controlled axes in high–speed ma-
chining (parameter No. 7150)
High–speed axis selection during high–speed
machining (bit 0 of parameter No. 7510)
20.6
DISTRIBUTION
PROCESSING
TERMINATION
MONITORING
FUNCTION FOR THE
HIGH–SPEED
MACHINING
COMMAND (G05)
Explanations
D High–speed machining
command
D Distribution processing
termination

Leave a Reply

Your email address will not be published. Required fields are marked *