FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
21. AXIS CONTROL FUNCTIONS
B–62764EN/01
482
(Example)
Machining program
N7000 M29 S1000 ;
N8000 G84 X20. Y20. R–10. Z–30. F500 ;
N8010 X50. Y50. ;
N8020 X100. Y100 . ;
G80 ;
Retreat program
IF [#mmm NE 29 ] GOTO 1000 ;
G30 P99 M29 S1000 ;
G00 Z–10. ;
G00 X#xxx Y#yyy Z#zzz ;
GOTO 2000 ;
NOTE
1 Rigid tapping cannot be restarted from an intermediate
hole. Be sure to restart rigid tapping at the rigid tapping start
block (M29).
2 If a value other than 0 is specified in parameter No. 5210,
specify the value in place of M29 in the program above.

Leave a Reply

Your email address will not be published. Required fields are marked *