FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
2. CONTROLLED AXES
B–62764EN/01
30
When a default axis name (1 to 8) is used, operation in the MEM mode
and MDI mode is disabled.
If a duplicate axis name is specified in the parameter, operation is enabled
only for the axis specified first.
NOTE
In two–path control, axis information displayed on the CRT
screen, such as the current position, may contain an axis
name with a suffix indicating the related path (X1, X2, etc).
This is intended to provide a comprehensible indication of
the path to which the axis belongs. The suffix cannot be
used in a program ; the axis name should be specified as X,
Y, Z, U, V, W, A, B, or C.
Limitations
D Default axis name
D Duplicate axis names

Leave a Reply

Your email address will not be published. Required fields are marked *