FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
1. GENERAL
B–62764EN/01
496
Automatic operation is to operate the machine according to the created
program. It includes memory, MDI and DNC operations. (See Section
III–4).
Program
Tool
01000 ;
M_S_T ;
G92_X_;
G00... ;
G01...... ;
.
.
.
.
Fig.1.2 (a) Tool Movement by Programming
After the program is once registered in memory of CNC, the machine can
be run according to the program instructions. This operation is called
memory operation.
CNC
Machine
Memory
Fig.1.2 (b) Memory Operation
After the program is entered, as an command group, from the MDI
keyboard, the machine can be run according to the program. This
operation is called MDI operation.
MDI keyboard CNC
Manual program
input
Machine
Fig.1.2 (c) MDI operation
In this mode of operation, the program is not registered in the CNC
memory. It is read from the external input/output devices instead. This
is called DNC operation. This mode is useful when the program is too
large to fit the CNC memory.
1.2
TOOL MOVEMENT
BY PROGRAMING
– AUTOMATIC
OPERATION
Explanations
D  
D MDI operation
D DNC operation

Leave a Reply

Your email address will not be published. Required fields are marked *