FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
1. GENERAL
B–62764EN/01
498
While automatic operation is being executed, tool movement can overlap
automatic operation by rotating the manual handle.
Z
X
Programmed
depth of cut
Depth of cut by
handle interruption
Tool position after
handle interruption
Tool position during
automatic operation
Fig.1.3 (c) Handle Interruption for Automatic Operation
D Handle interruption
(See Section III–4.6)

Leave a Reply

Your email address will not be published. Required fields are marked *