FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
1. GENERAL
501
After a created program is once registered in memory, it can be corrected
or modified from the CRT/MDI panel (See Section III–9).
This operation can be executed using the part program storage/edit
function.
Program registration
CRT/MDI
CNC
CNC
Program correction or modification
Tape reader
CNC tape (program)
Fig.1.5 (a) Part Program Editing
1.5
EDITING A PART
PROGRAM

Leave a Reply

Your email address will not be published. Required fields are marked *