FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
1. GENERAL
503
Machined
shape
1st tool path
2nd tool path
Offset value of the 1st tool
Offset value of the 2nd tool
Fig.1.6 (c) Offset Value
Apart from parameters, there is data that is set by the operator in
operation. This data causes machine characteristics to change.
For example, the following data can be set:
S Inch/Metric switching
S Selection of I/O devices
S Mirror image cutting on/off
The above data is called setting data (See Section III–11.4.3).
Setting
DisplayingScreen Keys
Setting data
Inch/Metric switching
Selection of I/O device
Mirror image ON/OFF setting
CNC Memory
Program
Automatic
operation
Operational
characteristics
Movement of
the machine
Fig.1.6 (d) Displaying and Setting Operators setting data
D Displaying and setting
operators setting data

Leave a Reply

Your email address will not be published. Required fields are marked *