FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
2. OPERATIONAL DEVICES
B–62764EN/01
524
Table2.2 Explanation of the MDI keyboard
Number ExplanationName
11 Cursor move keys There are four different cursor move keys.
: This key is used to move the cursor to the right or in the forward
direction. The cursor is moved in short units in the forward direction.
: This key is used to move the cursor to the left or in the reverse
direction. The cursor is moved in short units in the reverse direction.
: This key is used to move the cursor in a downward or forward
direction. The cursor is moved in large units in the forward direction.
: This key is used to move the cursor in an upward or reverse direction.
The cursor is moved in large units in the reverse direction.
12 Page change keys Two kinds of page change keys are described below.
: This key is used to changeover the page on the CRT screen in the
forward direction.
: This key is used to changeover the page on the CRT screen in the
reverse direction.
In the 2–path lathe control, be sure to select the tool post for which data
is specified, using the tool–post selection switch on the machine
operators panel. Then, perform keyboard operation, such as displaying
or specifying various data items, and editing a program.
PAGE
PAGE
PAGE
PAGE
Explanations
D 2–path lathe control

Leave a Reply

Your email address will not be published. Required fields are marked *