FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
4. AUTOMATIC OPERATION
591
By activating automatic operation during the DNC operation mode
(RMT), it is possible to perform machining (DNC operation) while a
program is being read in via reader/puncher interface, or remote buffer.
If the floppy cassette directory display option is available, it is possible
to select files (programs) saved in an external input/output unit of a floppy
format (Handy File, Floppy Cassettes, or FA card) and specify (schedule)
the sequence and frequency of execution for automatic operation.
(see III–4.4)
To use the DNC operation function, it is necessary to set the parameters
related to the reader/punch interface, and remote buffer in advance.
DNC OPERATION
1 Search for the program (file) to be executed.
2 Press the REMOTE switch on the machine operators panel to set
RMT mode, then press the cycle start switch. The selected file is
executed. For details of the use of the REMOTE switch, refer to the
relevant manual supplied by the machine tool builder.
PROGRAM CHECK O0001 N00020
N020 X100.0 Z100.0 (DNC–PROG) ;
N030 X200.0 Z200.0 ;
N050 X400.0 Z400.0 ;
(RELATIVE) (DIST TO GO) G00 G17 G90
X 100.000 X 0.000 G22 G94 G21
Y 100.000 Y 0.000 G41 G49 G80
Z 0.000 Z 0.000 G98 G50 G67
A 0.000 A 0.000 B
C 0.000 C 0.000 H M
HD.T NX.T D M
F S M
ACT.F SACT REPEAT
RMT STRT MTN *** *** 21:20:05
[ ABS ] [ REL ] [ ] [ ] [ (OPRT) ]
D Program check screen
(9 CRT)
4.3
DNC OPERATION


Leave a Reply

Your email address will not be published. Required fields are marked *