FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
4. AUTOMATIC OPERATION
B–62764EN/01
592
PROGRAM O0001 N00020
N020 X100.0 Z100.0 (DNC–PROG) ;
N030 X200.0 Z200.0 ;
N040 X300.0 Z300.0 ;
N050 X400.0 Z400.0 ;
N060 X500.0 Z500.0 ;
N070 X600.0 Z600.0 ;
N080 X700.0 Z400.0 ;
N090 X800.0 Z400.0 ;
N100 x900.0 z400.0 ;
N110 x1000.0 z1000.0 ;
N120 x800.0 z800.0 ;
RMT STRT MTN *** *** 21:20:05
[ PRGRM ] [ CHECK ] [ ] [ ] [ (OPRT) ]
D Program screen
(9 CRT/PDP, 8.4 LCD)
PROGRAM
N020 X100.0 (DNC–PROG) ;
N030 X90.0 ;
N040 X80.0 ;
N050 X70.0 ;
N060 X60.0 ;
N070 X50.0 ;
N080 X40.0 ;
N090 X30.0 ;
N100 X20.0 ;
N110 X10.0 ;
N120 X0.0 ;
N130 Z100.0 ;
N140 Z90.0 ;
N150 Z80.0 ;
N160 Z70.0 ;
N170 Z60.0 ;
F0001 N00020
N180 Z50.0 ;
N190 Z40.0 ;
N200 Z30.0 ;
N210 Z20.0 ;
N220 Z10.0 ;
N230 Z0.0 ;
N240 M02 ;
%
RMT STRT MTN *** *** 22:23:24
PRGR CHEC (OPR
M KT)
DProgram screen
(9.5LCD/14 CRT)
During DNC operation, the program currently being executed is
displayed on the program check screen and program screen.
The number of displayed program blocks depends on the program being
executed.
Any comment enclosed between a control–out mark (() and control–in
mark ()) within a block is also displayed.
D During DNC operation, programs stored in memory can be called.
D During DNC operation, macro programs stored in memory can be
called.
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *