FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
4. AUTOMATIC OPERATION
595
M198 cannot be executed in the input, output and run simultaneous mode.
An attempt to do so results in alarm No. 210.
A macro control command cannot be executed in the input, output and run
simultaneous mode. An attempt to do so results in P/S alarm No. 123.
If an alarm condition occurs during the input, output and run simultaneous
mode, a block being processed when the alarm condition occurs and all
blocks before that are input or output.
In the output and run simultaneous mode, if a device used is a floppy disk
drive or FA card, the file name is the execution program number.
When a program is being executed in the output and run simultaneous
mode, if a subprogram is called, only the main program is output.
Number Message Contents
123
CAN NOT USE MACRO
COMMAND IN DNC
Macro control command is used during
DNC operation.
Modify the program.
210
CAN NOT COMMAND
M198/M199
M198 or M199 is executed in the DNC
operation. M198 is executed in the
DNC operation. Modify the program.
222
DNC OP. NOT AL-
LOWED IN BG.–EDIT
Input and output are executed at a time
in the background edition.
Execute a correct operation.
Limitations
D M198 (command for
calling a program from
within an external
input/output unit)
D Macro control command
D Alarm
D File name
D Sub program call
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *