FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
4. AUTOMATIC OPERATION
597
Procedure for Program Restart by Specifying a Sequence Number
1 Retract the tool and replace it with a new one. When necessary,
change the offset. (Go to step 2.)
1 When power is turned ON or emergency stop is released, perform all
necessary operations at that time, including the reference position
return.
2 Move the machine manually to the program starting point (machining
start point), and keep the modal data and coordinate system in the
same conditions as at the machining start.
3 If necessary, modify the offset amount.
1 Turn the program restart switch on the machine operator’s panel ON.
2 Press
PROG
key to display the desired program.
3 Find the program head.
4 Enter the sequence number of the block to be restarted, then press th
[P TYPE] or [Q TYPE] soft key.
If the same sequence number appears more than once, the location of
the target block must be specified. Specify a frequency and a
sequence number.
Procedure 1
[ P TYPE ]
[ Q TYPE ]
Procedure 2
[COMMON TO P TYPE /
Q TYPE]
N
fffff
Sequence number
fff
[Q TYPE]
or
[P TYPE]
Frequency
N
fffff
Sequence number
[P TYPE]
or
[Q TYPE]

Leave a Reply

Your email address will not be published. Required fields are marked *