FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
4. AUTOMATIC OPERATION
609
For the two–path control, subprograms in a floppy cassette cannot be
called for the two tool posts at the same time.
NOTE
1 When M198 in the program of the file saved in a floppy
cassette is executed, a P/S alarm (No.210) is given. When
a program in the memory of CNC is called and M198 is
executed during execution of a program of the file saved in
a floppy cassette, M198 is changed to an ordinary M–code.
When MDI is intervened and M198 is executed after M198
is commanded in the memory mode, M198 is changed to an
ordinary M–code. When the reset operation is done in the
MDI mode after M198 is commanded in the MEMORY
mode, it does not influence on the memory operation and
the operation is continued by restarting it in the MEMORY
mode.
Restrictions
D Subprogram call
function with two–path
control

Leave a Reply

Your email address will not be published. Required fields are marked *