FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
4. INTERPOLATION FUNCTIONS
B–62764EN/01
42
D During canned cycle for drilling, no single direction positioning is
effected in Z axis.
D No single direction positioning is effected in an axis for which no
overrun has been set by the parameter.
D When the move distance 0 is commanded, the single direction
positioning is not performed.
D The direction set to the parameter is not effected by mirror image.
D The single direction positioning does not apply to the shift motion in
the canned cycles of G76 and G87.
Restrictions

Leave a Reply

Your email address will not be published. Required fields are marked *