FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
4. AUTOMATIC OPERATION
B–62764EN/01
614
2–4 Move the cursor to the mirror image setting position, then set the
target axis to 1.
3 Enter an automatic operation mode (memory mode or MDI mode),
then press the cycle start button to start automatic operation.
D The mirror image function can also be turned on and off by setting bit
0 of parameter 0012 (MIRx) to 1 or 0.
D For the mirror image switches, refer to the manual supplied by the
machine tool builder.
The direction of movement during manual operation, the direction of
movement from an intemidiate point to the reference position during
automatic reference position return (G28), the direction of approach
during unidirectional positioning (G60), and the shift direction in a boring
cycle (G76, G87) cannot be reserved.
Explanations
Limitations

Leave a Reply

Your email address will not be published. Required fields are marked *