FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
4. AUTOMATIC OPERATION
B–62764EN/01
618
After withdrawing the tool and any additional operation such as replacing
the tool, move the tool back to the previous retraction position.
To return the tool to the retraction position, return the mode to automatic
operation mode, then turn the TOOL RETURN switch on the operator’s
panel on then off again. The tool returns to the retraction position at the
dry run feedrate, regardless of whether the dry run switch is on or off.
When the tool has returned to the retraction position, the RETRACTION
POSITION LED comes on.
X
Y
Z
1
2
3
4
56
7
8
9
10
11
12
A point
E point
During return operation, the CRT screen displays PTRR and MSTR.
MEM MSTR MTN ***
0 : 00 : 00 PTRR
S PTRR blinks in the field for indicating states such as program editing
status.
S MSTR is displayed in the automatic operation status field.
S MTN is displayed in the field for indicating states such as movement
along an axis.




Leave a Reply

Your email address will not be published. Required fields are marked *