FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
4. AUTOMATIC OPERATION
631
The retreat and retry functions incorporate those functions that are needed
to enable retreat and retry operations with a PMC and custom macros.
Even if machining is interrupted by a reset or emergency stop, the tool can
be returned from the interruption point (retreat function) to restart
machining from the start block of the interrupted machining (retry
function) easily.
4.13
RETREAT AND
RETRY FUNCTION

Leave a Reply

Your email address will not be published. Required fields are marked *