5. TEST OPERATION
An override of four steps (F0, 25%, 50%, and 100%) can be applied to the
rapid traverse rate. F0 is set by a parameter (No. 1421).
Fig. 5.3 Rapid traverse override
Rapid Traverse Override
Select one of the four feedrates with the rapid traverse override switch
during rapid traverse. Refer to the appropriate manual provided by the
machine tool builder for rapid traverse override.
The following types of rapid traverse are available. Rapid traverse
override can be applied for each of them.
1) Rapid traverse by G00
2) Rapid traverse during a canned cycle
3) Rapid traverse in G27, G28 and G30
4) Manual rapid traverse
5) Rapid traverse of manual reference position return
Rapid traverse override