FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
5. TEST OPERATION
641
Pressing the single block switch starts the single block mode. When the
cycle start button is pressed in the single block mode, the tool stops after
a single block in the program is executed. Check the program in the single
block mode by executing the program block by block.
Cycle start
Stop
Workpiece
Cycle start
Cycle start
Stop
Stop
Tool
Fig. 5.5 (b) Single block
Procedure for Single block
1 Press the single block switch on the machine operators panel. The
execution of the program is stopped after the current block is
executed.
2 Press the cycle start button to execute the next block. The tool stops
after the block is executed.
Refer to the appropriate manual provided by the machine tool builder
for single block execution.
5.5
SINGLE BLOCK


Leave a Reply

Your email address will not be published. Required fields are marked *