FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
6. SAFETY FUNCTIONS
B–62764EN/01
652
In cylindrical interpolation mode, no check is made.
In polar coordinate interpolation mode, no check is made.
When the angulalr axis control option is selected, no check is made.
In simple synchronous control, only the master axis is checked; no slave
axes are checked.
In three–dimensional coordinate conversion mode, no check is made.
No check is performed while drawing is being performed as part of
dynamic graphic display (while only drawing (no machining) is being
performed).
No check is made for a movement based on PMC axis control.
No check is made for a movement based on high–speed, high–precision
contour control (HPCC).
Number Message Contents
510 OVER TRAVEL : +n
The pre–movement stroke limit check re-
veals that the block end point enters the
prohibited area for the positive stroke limit
along the n axis. Correct the program.
511 OVER TRAVEL : –n
The pre–movement stroke limit check re-
veals that the block end point enters the
prohibited area for the negative stroke limit
along the n axis. Correct the program.
D Cyrindrical interpolation
mode
D Polar coordinate
interpolation mode
D Angular axis control
D Simple synchronous
control
D Three–dimensional
coordinate conversion
D Drawing
D PMC axis control
D High–speed
high–precision contour
control (HPCC)
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *