FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
8. DATA INPUT/OUTPUT
B–62764EN/01
664
Alarm No. Description
86
The ready signal (DR) of an input/output device is off.
An alarm is not immediately indicated in the CNC even when an
alarm occurs during head searching (when a file is not found, or
the like).
An alarm is given when the input/output operation is performed
after that. This alarm is also raised when N1 is specified for writ-
ing data to an empty floppy. (In this case, specify N0.)


Leave a Reply

Your email address will not be published. Required fields are marked *