FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
8. DATA INPUT/OUTPUT
B–62764EN/01
668
S Pressing the [CHAIN] soft key positions the cursor to the end of the
registered program. Once a program has been input, the cursor is
positioned to the start of the new program.
S Additional input is possible only when a program has already been
registered.
If an attempt has been made to register a program having the same number
as that of a previously registered program, P/S alarm 073 is issued and the
program cannot be registered.
Alarm No. Description
70
The size of memory is not sufficient to store the input pro-
grams
73
An attempt was made to store a program with an existing pro-
gram number.
79
The verification operation found a mismatch between a pro-
gram loaded into memory and the contents of the program on
the floppy or NC tape.
D Defining the same
program number as that
of an existing program


Leave a Reply

Your email address will not be published. Required fields are marked *