FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
8. DATA INPUT/OUTPUT
B–62764EN/01
670
Head searching with a file No. is necessary when a file output from the
CNC to the floppy is again input to the CNC memory or compared with
the content of the CNC memory. Therefore, immediately after a file is
output from the CNC to the floppy, record the file No. on the memo.
Punch operation can be performed in the same way as in the foreground.
This function alone can punch out a program selected for foreground
operation.
<O> (Program No.)
[PUNCH] [EXEC]: Punches out a specified program.
<O> H–9999I
[PUNCH] [EXEC]: Punches out all programs.
A program is output to paper tape in the following format:
ER
(%)
Program
Feed of 3 feet
Feed of 3 feet
ER
(%)
If three–feet feeding is too long, press the
CAN
key during feed
punching to cancel the subsequent feed punching.
A space code for TV check is automatically punched.
When a program is punched in ISO code, two CR codes are punched after
an LF code.
LF CR CR
By setting NCR (bit 3 of parameter No. 0100), CRs can be omitted so that
each LF appears without a CR.
Press the
RESET
key to stop punch operation.
All programs are output to paper tape in the following format.
Program Program Program
Feed of 1–feet
Feed of 3–feet
ER
(%)
ER
(%)
The sequence of the programs punched is undefined.
D On the memo record
D Punching programs in
the background
Explanations
(Output to an NC tape)
D Format
D TV check
D ISO code
D Stopping the punch
D Punching all programs

Leave a Reply

Your email address will not be published. Required fields are marked *