FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
8. DATA INPUT/OUTPUT
B–62764EN/01
672
All offset data is output in a output format from the memory of the CNC
to a floppy or NC tape.
Outputting offset data
1 Make sure the output device is ready for output.
For the two–path control, select the tool post for which offset data to
be input is used with the tool post selection switch.
2 Specify the punch code system (ISO or EIA) using a parameter.
3 Press the EDIT switch on the machine operators panel.
4 Press function key
OFFSET
SETTING
, then the tool compensation screen appears.
5 Press soft key
[(OPRT)].
6 Press the rightmost soft key
(next–menu key)
7 Press soft keys
[PUNCH] and [EXEC].
Offset data is output in the output format described below.
Output format is as follows:
Format
(1)For tool compensation memory A
G10 L11 P_R_;
where P_: Offset No.
R_: Tool compensation amount
(2)For tool compensation memory B
Setting/changing the geometric compensation amount
G10 L10 P_R_;
Setting/changing the wear compensation amount
G10 L11 P_R_;
(3)For tool compensation memory C
Setting/changing the geometric compensation amount for H code
G10 L10 P_R_;
Setting/changing the geometric compensation amount for D code
G10 L12 P_R_;
Setting/changing the wear compensation amount for H code
G10 L11 P_R_;
Setting/changing the wear compensation amount for D code
G10 L13 P_R_;
The L1 command may be used instead of L11 for format compatibility of
the conventional CNC.
When the floppy disk directory display function is used, the name of the
output file is OFFSET.
8.5.2
Outputting Offset Data
Procedure
Explanations
D Output format
D Output file name

Leave a Reply

Your email address will not be published. Required fields are marked *