FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
8. DATA INPUT/OUTPUT
673
Parameters and pitch error compensation data are input and output from
different screens, respectively. This chapter describes how to enter them.
Parameters are loaded into the memory of the CNC unit from a floppy or
NC tape. The input format is the same as the output format. See
III–8.6.2.
When a parameter is loaded which has the same data number as a
parameter already registered in the memory, the loaded parameter
replaces the existing parameter.
Inputting parameters
1 Make sure the input device is ready for reading.
For the two–path control, select the tool post for which parameters to
be input are used with the tool post selection switch.
2 When using a floppy, search for the required file according to the
procedure in
III–8.2.
3 Press the EMERGENCY STOP button on the machine operators
panel.
4 Press function key
OFFSET
SETTING
.
5 Press the soft key
[SETING] for chapter selection, then the setting
screen appears.
6 Enter 1 in response to the prompt for “PARAMETER WRITE
(PWE)” in setting data. Alarm P/S100 (indicating that parameters can
be written) appears.
7 Press soft key
SYSTEM
.
8 Press chapter selection soft key
[PARAM], then the parameter screen
appears.
9 Press soft key
[(OPRT)].
10 Press the rightmost soft key
(next–menu key).
11 Press soft keys
[READ] and [EXEC].
Parameters are read into memory. Upon completion of input, the
“INPUT” indicator at the lower–right corner of the screen disappears.
12 Press function key
OFFSET
SETTING
.
13 Press soft key
[SETING] for chapter selection.
14 Enter 0 in response to the prompt for “PARAMETER WRITE
(PWE)” in setting data.
8.6
INPUTTING AND
OUTPUTTING
PARAMETERS AND
PITCH ERROR
COMPENSATION DATA
8.6.1
Inputting Parameters


Leave a Reply

Your email address will not be published. Required fields are marked *