FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
8. DATA INPUT/OUTPUT
675
When the floppy disk directory display function is used, the name of the
output file is PARAMETER.
Once all parameters have been output, the output file is named ALL
PARAMETER. Once only parameters which are set to other than 0 have
been output, the output file is named NON–0. PARAMETER.
Pitch error compensation data are loaded into the memory of the CNC
from a floppy or NC tape. The input format is the same as the output
format. See
III–8.6.4. When a pitch error compensation data is loaded
which has the corresponding data number as a pitch error compensation
data already registered in the memory, the loaded data replaces the
existing data.
Pitch error compensation data
1 Make sure the input device is ready for reading.
For the two–path control, select the tool post for which pitch error
compensation data to be input is used with the tool post selection
switch.
2 When using a floppy, search for the required file according to the
procedure in III–
8.2.
3 Press the EMERGENCY STOP button on the machine operators
panel.
4 Press function key
OFFSET
SETTING
.
5 Press the soft key
[SETING] for chapter selection.
6 Enter 1 in response to the prompt for writing parameters (PWE).
Alarm P/S100 (indicating that parameters can be written) appears.
7 Press soft key
SYSTEM
.
8 Press the rightmost soft key
(next–menu key)and press
chapter selection soft key
[PITCH].
9 Press soft key
[(OPRT)].
10 Press the rightmost soft key
(next–menu key).
11 Press soft keys
[READ] and [EXEC].
Parameters are read into memory. Upon completion of input, the
“INPUT” indicator at the lower–right corner of the screen disappears.
12 Press function key
OFFSET
SETTING
.
13 Press soft key
[SETING] for chapter selection.
14 Enter 0 in response to the prompt for “PARAMETER WRITE
(PWE)” in setting data.
D Output file name
8.6.3
Inputting Pitch error
compensation data
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *