FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
8. DATA INPUT/OUTPUT
B–62764EN/01
684
Any program in the memory of the CNC unit can be output to a floppy
as a file.
Outputting programs
1 Press the EDIT switch on the machine operators panel.
For the two–path control, select the tool post for which a file is to be
input in memory with the tool post selection switch.
2 Press function key
PROG
.
3 Press the rightmost soft key
(next–menu key).
4 Press soft key [FLOPPY].
5 Press soft key [(OPRT)].
6 Press soft key [PUNCH].
EDIT
**** *** ***
11 : 55 : 26
PUNCH
FILE NO. =
>_
O0002 N01000
(METER) VOL
DIRECTORY (FLOPPY)
NO. FILE NAME
CAN
F SET
EXEC
PROGRAM NO. =
O SET
STOP
0001 PARAMETER
0002 O0001
0003 O0002
0004 O0010
0005 O0040
0006 O0050
0007 O0100
0008 O1000
0009 O9500
58.5
1.9
1.9
1.3
1.3
1.9
1.9
1.9
1.6
7 Enter a program number. To write all programs into a single file, enter
–9999 in the program number field. In this case, the file name
ALL.PROGRAM” is registered.
8 Press soft key
[O SET].
9 Press soft key
[EXEC]. The program or programs specified in step 7
are written after the last file on the floppy. To output the program after
deleting files starting with an existing file number, key in the file
number, then press soft key
[F SET] followed by soft key [EXEC].
10 Press soft key
[CAN] to return to the soft key display shown in
the screen of Fig.8.8.1(a).
8.8.3
Outputting Programs


Leave a Reply

Your email address will not be published. Required fields are marked *