FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
9. EDITING PROGRAMS
B–62764EN/01
704
A new program can be created by copying a program.
A
Oxxxx
A
Oxxxx
After copy
A
Oyyyy
Copy
Before copy
Fig. 9.6.1 Copying an Entire Program
In Fig. 9.6.1, the program with program number xxxx is copied to a newly
created program with program number yyyy. The program created by
copy operation is the same as the original program except the program
number.
Procedure of copying an entire program
1 Enter the EDIT mode.
2 Press function key
PROG
.
3 Press soft key
[(OPRT)].
4 Press the continuous menu key.
5 Press soft key
[EX–EDT].
6 Check that the screen for the program to be copied is selected
and press soft key
[COPY].
7 Press soft key
[ALL].
8 Enter the number of the new program (with only numeric keys ) and
press the
INPUT
key.
9 Press soft key
[EXEC].
9.6.1
Copying an Entire
Program
Continuous
menu key
0 9
Numeric keys
(OPRT)
(EX–EDT)
COPY
ALL
EXEC

Leave a Reply

Your email address will not be published. Required fields are marked *