FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
9. EDITING PROGRAMS
705
A new program can be created by copying part of a program.
B
Oxxxx
Oxxxx
After copy
B
Oyyyy
Copy
Before copy
Fig. 9.6.2 Copying Part of a Program
A
C
B
A
C
In Fig. 9.6.2, part B of the program with program number xxxx is copied
to a newly created program with program number yyyy. The program for
which an editing range is specified remains unchanged after copy
operation.
Procedure for copying part of a program
1 Perform steps 1 to 6 in III–9.6.1.
2 Move the cursor to the start of the range to be copied and press soft key
[CRSR].
3 Move the cursor to the end of the range to be copied and press soft key
[CRSR] or [BTTM] (in the latter case, the range to the end of the
program is copied regardless of the position of the cursor).
4 Enter the number of the new program (with only numeric keys) and
press the
INPUT
key.
5 Press soft key
[EXEC].
9.6.2
Copying Part
of a Program
CRSR
0 9
CRSR BTTM
EXEC
Numeric keys

Leave a Reply

Your email address will not be published. Required fields are marked *