FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
9. EDITING PROGRAMS
B–62764EN/01
706
A new program can be created by moving part of a program.
B
Oxxxx Oxxxx
After copy
B
Oyyyy
Copy
Before copy
Fig. 9.6.3 Moving Part of a Program
A
C
A
C
In Fig. 9.6.3, part B of the program with program number xxxx is moved
to a newly created program with program number yyyy; part B is deleted
from the program with program number xxxx.
Procedure for moving part of a program
1 Perform steps 1 to 5 in III–9.6.1.
2 Check that the screen for the program to be moved is selected and
press soft key
[MOVE].
3 Move the cursor to the start of the range to be moved and press soft
key
[CRSR].
4 Move the cursor to the end of the range to be moved and press soft key
[CRSR] or [BTTM](in the latter case, the range to the end of the
program is copied regardless of the position of the cursor).
5 Enter the number of the new program (with only numeric keys) and
press the
INPUT
key.
6 Press soft key
[EXEC].
9.6.3
Moving Part of a
Program
CRSR
EXEC
0 9
Numeric keys
CRSR BTTM
MOVE

Leave a Reply

Your email address will not be published. Required fields are marked *