FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
10. CREATING PROGRAMS
B–62764EN/01
722
The contents of memory can be checked in the TEACH IN mode by using
the same procedure as in
EDIT mode.
PROGRAM O1234 N00004
(RELATIVE)(ABSOLUTE)
X –6.975 X 3.025
Y 23.723 Y 23.723
Z –10.325 Z –0.325
O1234 ;
N1 G92 X10000 Y0 Z10000 ;
N2 G00 G90 X3025 Y23723 ;
N3 G01 Z–325 F300 ;
N4 M02
%
THND
* * * *
* * * * * *
14 : 17 : 27
LIB
(OPRT)
;
_
PRGRM
When a value is keyed in after keying in address
X
,
Y
, or
Z
,
then the
INSERT
key is pressed, the value keyed in for a machine position
is added for registration. This operation is useful to correct a machine
position by key–in operation.
Commands to be entered before and after a machine position must be
entered before and after the machine position is registered, by using the
same operation as program editing in
EDIT mode.
Explanations
D Checking contents of the
memory
D Registering a position
with compensation
D Registering commands
other than position
commands

Leave a Reply

Your email address will not be published. Required fields are marked *