FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
10. CREATING PROGRAMS
725
**** *** ***
O0010 N00000
PROGRAM
GGGG
XY
Z
HF
RM
ST
B I
JK
PQ
L
:
EDIT 14 : 41 : 10
(OPRT)
PRGRM
G.MENU
BLOCK
7 Move the cursor to the block to be modified on the program screen.
At this time, a data address with the cursor blinks.
8 Enter numeric data by pressing the numeric keys and press the
[INPUT] soft key or
INPUT
key. This completes the input of one data
item.
9 Repeat this operation until all data required for the entered G code is
entered.
10 Press the
INSERT
key. This completes the registration of data of one
block in program memory. On the screen, the G code menu screen is
displayed, allowing the user to enter data for another block. Repeat
the procedure starting with 5 as required.
11 After registering all programs, press the
[PRGRM] soft key. The
registered programs are converted to the converssational format and
displayed.
12 Press the
RESET
key to return to the program head.
1 Move the cursor to the block to be modified on the program screen
and press the
[C.A.P] soft key. Or, press the [C.A.P] soft key first to
display the conversational screen, then press the
or page
key until the block to be modified is displayed.
2 When data other than a G code is to be altered, just move the cursor to
the data and key in a desired value, then press the
[INPUT] soft key or
INPUT
key.
3 When a G code is to be altered, press the menu return key
and the
soft key
[G.MENU]. Then the G code menu appears. Select a desired
G code, then key in the value. For example, to specify a cutting feed,
since the G code menu indicates G01, key in G01. Then press the soft
key
[BLOCK]. The detailed screen of the G code is displayed, so enter
the data.
Procedure
 a block

Leave a Reply

Your email address will not be published. Required fields are marked *