FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
10. CREATING PROGRAMS
B–62764EN/01
726
4 After data is changed completely, press the
ALTER
key. This operation
replaces an entire block of a program.
1 On the conversational screen, display the block immediately before a
new block is to be inserted, by using the page keys. On the program
screen, move the cursor with the page keys and cursor keys to
immediately before the point where a new block is to be inserted.
2 Press the soft key [G.MENU] to display the G code menu. Then enter
new block data.
3 When input of one block of data is completed in step 2, press the
INSERT
key. This operation inserts a block of data.
1 On the conversational screen, display the contents of a block to be
deleted, then press the
DELETE
key.
2 The contents of the block displayed are deleted from program
memory. Then the contents of the next block are displayed on the
conversational screen.
Procedure
Inserting a block
Procedure
Deleting a block

Leave a Reply

Your email address will not be published. Required fields are marked *